Hard Drive Backplane - Dell PowerEdge R330 Owner's Manual

Figure 82. Removing the system battery
1. plastic scribe
3. securing tabs
3. Install a new system battery by holding the battery with the "+" sign facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 83. Installing the system battery
1. positive side of the battery connector
Next steps
1. Install the expansion card riser.
2. Follow the procedure listed in the After working in your system section.
3. While booting, press F2 to enter System Setup and ensure that the battery is operating properly.
4. Enter the correct time and date in the System Setup Time and Date fields.
5. Exit System Setup.
Related links
Removing the expansion card riser
Installing the expansion card riser

Hard drive backplane

Depending on your system configuration, PowerEdge R330 supports:
• Four 3.5-inch or 2.5-inch SAS/SATA backplane or
• Eight 2.5-inch SAS/SATA backplane
2. positive side of the battery connector
2. battery connector
121