Installing The Power Interposer Board - Dell PowerEdge R330 Owner's Manual

NOTE: For systems without a hard drive backplane, do not connect the 10 pin cable.
Next steps
1. Install the power interposer board.
2. Follow the procedure listed in the After working inside your system section.
Related links
Removing a redundant power supply unit

Installing the power interposer board

Installing the power interposer board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Keep the Phillips #2 screwdriver ready.
Steps
1. Align the power interposer board (PIB) with the standoffs on the chassis.
2. Install the two screws that secure the PIB to the chassis.
3. Connect the power distribution cables to the system board and the hard drive power connector to the hard drive backplane.
Figure 103. Installing the power interposer board
1. standoffs (2)
3. power interposer board
5. 28 pin cable to system board
7. 8 pin cable to system board
Safety instructions.
Before working inside your system.
2. 10 pin cable to hard drive backplane
4. screw (2)
6. 4 pin cable to system board
139