Control Panel Assembly; Removing The Lcd Control Panel Assembly - Dell PowerEdge R330 Owner's Manual

Figure 93. Installing the eight 2.5 inch SAS/SATA backplane
1. hard-drive/SSD backplane
3. backplane signal cable
5. release tab (2)
7. hard-drive/SSD connector (8)
Next steps
1. Install the hard drives in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related links
Installing a hot swappable hard drive carrier

Control panel assembly

This section provides information about removing or installing the LCD control panel assembly.

Removing the LCD control panel assembly

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #2 screwdriver ready.
Steps
1. Disconnect the cables from the control panel board.
2. backplane power cable
4. SAS_A cable connector
6. SAS_B cable connector
131