Dell PowerEdge R330 Owner's Manual page 91

1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the expansion card riser.
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the System board jumpers and connectors section.
2. If installed, remove the USB memory key from the USB port.
Figure 53. Removing the internal USB memory key
1. USB memory key
3. Insert the replacement USB memory key into the USB port.
Figure 54. Installing the internal USB memory key
1. USB memory key
Next steps
1. Install the expansion card riser.
2. Follow the procedure listed in the After working inside your system section.
3. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Related links
Removing the expansion card riser
Installing the expansion card riser
2. USB port
2. USB port
91