Removing The Expansion Card Riser - Dell PowerEdge R330 Owner's Manual

Card priority Card type
4 1 Gb NICs
5 Non-RAID

Removing the expansion card riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Lift and rotate the expansion card riser latch to open it.
2. Holding the touch points, lift the expansion card riser from the riser connector on the system board.
Slot priority
and Emulex
LPE15002
Qlogic QLE2562, 1
Qlogic QLE2560,
Emulex LPE12002,
Emulex LPE12000,
Emulex LPE15000,
and Emulex
LPE15002 Low
Profile
Intel and Broadcom 2
Dual and Quad Port
Intel and Broadcom 1
Dual and Quad Port
Low Profile
12GB SAS HBA Full 2
Height
12GB SAS HBA Low 1
Profile
Maximum allowed
1
1
1
1
1
93