Installing The Supercapacitor - Dell SD7000-S Owner's Manual

3. Remove the expansion-card riser module.
Steps
1. Insert the expansion card into the riser card until the card is fully seated.
2. Secure the expansion card with the screw.
Next steps
1. Install the expansion-card riser module on the system board.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
After working inside your system

Installing the supercapacitor

Prerequisites
NOTE: Only supported cards from Dell can be installed in the system.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the expansion-card riser module.
4. Remove the expansion card.
Steps
Follow the illustrations below to install the supercapacitor.
58