Recommended Tools; System Cover; Removing The System Cover - Dell SD7000-S Owner's Manual

Steps
1. Install the system cover.
2. Reconnect the peripherals and connect the system to the electrical outlet.
3. Turn on the system, including any attached peripherals.
Related Links
Installing the system cover

Recommended tools

You need the following tools to perform the removal and installation procedures:
• Phillips #2 screwdriver
• Wrist grounding strap connected to the ground

System cover

The system cover protects the components inside the system and helps in maintaining air flow inside the
system. Removing the system cover actuates the intrusion switch which aids in maintaining system
security.

Removing the system cover

Prerequisites
1. Follow the safety guidelines listed in safety instructions section.
2. Turn off the system, including any attached peripherals.
3. Disconnect the system from the electrical outlet and peripherals.
Steps
1. Loosen the screw from the system cover.
2. Slide the four release latches as indicated by the directional arrows on the latches.
3. Hold the cover on both sides, and lift the cover away from the system.
50