Troubleshooting An Internal Usb Key - Dell SD7000-S Owner's Manual

Storage designed for scality ring

Table of Contents

13. To troubleshoot an unspecified faulty memory module, replace the memory module in the first

DIMM socket with a module of the same type and capacity.

If an error message is displayed on the screen, this may indicate a problem with the installed DIMM

type(s), incorrect DIMM installation, or defective DIMM(s). Follow the on-screen instructions to

resolve the problem.

14. Install the system cover.

15. As the system boots, observe any error message that is displayed and the diagnostic indicators on the

front of the system.

16. If the memory problem persists, repeat step 12 through step 15 for each memory module installed.

Next steps

If the problem persists, see the Getting help section.

Troubleshooting an internal USB key

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only

perform troubleshooting and simple repairs as authorized in your product documentation, or as

directed by the online or telephone service and support team. Damage due to servicing that is

not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that are shipped with your product.

Steps

Enter System Setup and ensure that the USB key port is enabled on the Integrated Devices screen.

Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.

Remove the system cover.

Locate the USB key and reseat it.

Install the system cover.

Turn on the system and attached peripherals, and check if the USB key is functioning.

If the problem is not resolved, repeat step 2 and step 3.

Insert a known working USB key.

Install the system cover.

Next steps

If the problem persists, see the Getting help section.

Table of Contents