Installing The Cooling Shroud; System Memory - Dell SD7000-S Owner's Manual

Figure 14. Removing and installing the cooling shroud.
1. screw (3)

Installing the cooling shroud

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
Place the shroud in place on the system board and secure the three screws.
Next steps
1. Connect the CPU2 power cable.
2. Install the expansion-card riser module.
3. Follow the procedure listed in the After working inside your system section.

System memory

Your system supports DDR4 registered DIMMs (RDIMMs). It supports DDR4 voltage specifications.
NOTE: MT/s indicates DIMM speed in MegaTransfers per second.
Memory bus operating frequency is 2133 MT/s based on:
• System profile selected — Performance Optimized.
62
2. cooling shroud