Installing System Components
NOTE: Solution validation was performed using the factory shipped hardware configuration.
Recommended Tools
You may need the following items to perform the procedures in this section:
•
Key to the system keylock
•
#1 and #2 Phillips screwdrivers
•
T10 and T15 Torx screwdrivers
•
Wrist grounding strap connected to ground
Front Bezel (Optional)
Removing The Front Bezel
1.
Unlock the keylock at the left end of the bezel.
2.
Lift the release latch next to the keylock.
3.
Rotate the left end of the bezel away from the front panel.
4.
Unhook the right end of the bezel and pull the bezel away from the system.
Figure 6. Removing and Installing the Front Bezel
1. release latch
2. keylock
3. front bezel
4. locking hook
3
27