Oracle SPARC S7-2 Installation Manual page 58

Power on the Server for the First Time
Note -
password (changeme) to enable first-time login and access to Oracle ILOM. To build a secure
environment, you must change the default password of the default Administrator account as
soon as possible after your initial login to Oracle ILOM. If you find this default Administrator
account has already been changed, contact your system administrator to obtain an Oracle ILOM
user account with Administrator privileges.
For more information about the administration tasks such as changing passwords, adding
accounts, and setting account privileges, refer to the Oracle ILOM documentation.
Note -
to assign a static IP address to the SP, see
Port" on page 67
Power on the server using one of the following methods:
2.
Press the power button.
■
At the Oracle ILOM prompt, type:
■
-> start /System
Are you sure you want to start /System (y/n)? y
The server initialization might take several minutes to complete.
Note -
can use the legacy name in a command at any time, but to expose the legacy name in the output,
you must enable it with ->
Oracle ILOM documentation.
3. (Optional) Redirect the host output to display on the serial terminal device.
-> start /HOST/console
Are you sure you want to start /HOST/console (y/n)? y
Serial console started.
. . .
4. (Optional) You can execute other Oracle ILOM commands while the server
initializes.
58 SPARC S7-2 Server Installation Guide • July 2016
The server is provided with a default Administrator account (root) and a default
By default, the SP is configured to use DHCP to obtain an IP address. If you plan
for more instructions.
In Oracle ILOM 3.1 and later, the name space for /SYS was replaced with /System. You
set /SP/cli legacy_targets=enabled
"Assign a Static IP Address to the NET MGT
. For more information, see the