Firmware Update; Accessing The Jcu Ii Web Interface - FLIR M400 Installation Manual

M400 Web Browser Interface

Firmware Update

When software updates become available, use the Firmware Update field to load the update to the
camera. Contact the FLIR dealer where you purchased the camera for additional information, or
contact FLIR directly.
Maintenance->Files->Firmware

Accessing the JCU II Web Interface

The JCU II communicates through the Ethernet IP protocol just like the M400 camera does.
Changing the IP Address of the JCU II
On the JCU II, the IP address is displayed by pressing the COLOR button and pushing the joystick
forward at the same time. The IP addresses of the JCU II and the camera are displayed for 3
seconds and then the display returns to its state before the IP request was made.
On networks with specific requirements, you may need to assign the JCU II a static IP address. Do
this using steps similar to the way you changed the camera IP address:
1. Determine the JCU II IP address by pressing the COLOR button and pushing the joystick
forward at the same time. The IP address is shown on the JCU II screen.
2. Type the JCU II IP address into the address bar of the browser adding /index.html.
for example: http://192.168.250.110/index.html
The JCU II Web page is shown, with a picture of the JCU II.
432-0012-00-12 Version 110
Click to stop server. The server must be stopped
to upload or download any files.
July 2016 39