Changing The Ip Address Of The Camera - FLIR M400 Installation Manual

M400 Web Browser Interface
Maintenance->Server->Server Status
The page provides an indication of the current server status (either running or stopped) and
buttons for starting or stopping the server or for rebooting the system. Scroll down to see
additional status information which may be useful to FLIR technical support.

Changing the IP Address of the Camera

The admin and expert log in accounts can change LAN settings.
Maintenance->Server->LAN Settings
The M400 system is shipped with DHCP IP address mode enabled. Some networks may require
that a static IP address is set. The camera IP address, mask, and gateway is shown in the figure
below. A Static option is selected with an IP address of 192.168.250.116.
Select the Static or DHCP option. The screen will refresh, enter the appropriate information for the
network, then scroll down to select the Save button at the bottom of the page.
432-0012-00-12 Version 110 July 2016
Scroll down
to Save
31