6. Remove the brake disc assembly from the axle.
7. Loosen the drive chain (see Section 2); then slip
the chain off the sprocket and remove the axle
assembly from the right side.
8. Remove the cap screw from the rear brake caliper
holder; then remove the snap ring securing the cal-
iper holder to the axle housing.
Back
KM471
KM472
KM476A
Back to TOC
9. Remove the brake caliper holder and aligning col-
lar. Account for the O-ring.
10. Remove the four cap screws from the rear of the
swing arm assembly; then remove the rear axle
housing from the right side of the swing arm.
11. Remove the snap ring securing the driven sprocket
to the axle; then remove the sprocket.
CLEANING AND INSPECTING
1. Inspect the sprocket teeth for wear. If they are
worn as shown, replace the engine sprocket, rear
sprocket, and drive chain as a set.
Back to Section TOC
KM481A
KM483
6
KM477
Next
6-3