Arctic Cat ATV 250 Utility 2009 Service Manual page 42

5. Align the inner hook of the spiral spring with the
notch in the reel spacer.
6. Install the ratchets making sure the ends are prop-
erly oriented on the reel.
7. Install the spacer, spring, and the ratchet guide
making sure the ratchet pins engage the guide.
Back
KM400
KM405
KM402A
KM397A
Back to TOC
8. Hold the ratchet guide down in place on the ratchet
pins and secure with the cap screw coated with
blue Loctite #243. Tighten securely.
9. With the 50 cm (20 in.) of rope exposed, hook the
rope in the notch of the reel.
10. Rotate the reel four turns clockwise; then release
the rope from the notch and allow the rope to
retract.
11. Pull the rope out two or three times to check for
correct tension and ratchet extender.
NOTE: Increasing the rotations in step 10 will
increase spring tension.
12. Place the recoil starter assembly into position on
the left-side cover; then tighten the cap screws to
securely.
Back to Section TOC
KM401
3
KM410
KM412
Next
3-19