Arctic Cat ATV 250 Utility 2009 Service Manual page 122

2. Disconnect the negative battery cable first; then
the positive cable.
3. Remove the battery hold-down strap; then remove
the battery.
4. Remove the front and rear racks; then remove the
cap screws securing the front center panel and
remove the panel.
5. Remove the cap screws and flange nuts securing
the mud guards to the front and rear fenders; then
remove the cap screws securing the mud guards to
the front rests and remove the mud guards.
6. Remove the side panels; then remove the cap
screws and flange nuts securing the front and rear
fenders to the frame and fender supports.
Back
8-6
KM793A
KM308A
KM789A
Back to TOC
7. Disconnect the left and right headlight connectors;
then disconnect the taillight.
8. Remove the gas tank cover; then remove the shift
knob and front and rear fenders.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all body components with soap and water.
2. Inspect the body and fenders for cracks.
3. Inspect threaded areas of all mounting studs for
stripping.
4. Inspect for missing decals.
INSTALLING (DVX 300)
1. Fit the body over the handlebar and rotate into nor-
mal mounting position.
2. Using the existing hardware, secure the front fend-
ers to the fender supports; then connect the head-
light.
3. Using the existing hardware, secure the rear fend-
ers to the forward fender supports; then secure the
rear fender to the frame with four cap screws and
flange nuts. Tighten securely.
4. Install the six cap screws securing the body to the
top of the frame. Tighten securely.
Back to Section TOC
KM799B
KM797
Next