Aups Supported By Rx3I Cpe305/Cpe310 Embedded Ethernet Interface - GE RX3i User Manual

TCP Parameters (task w)
wnodelay TCP nodelay option (0= inactive; 1 = active)
26
wkal_idle TCP keepalive timer value (in seconds)
26
wkal_cnt TCP keepalive extra probe count
26
(in addition to single probe always performed)
wkal_intvl TCP keepalive probe interval (in seconds)
26
wsnd_buf TCP send buffer size (in bytes)
26
wrcv_buf TCP receiv
26
A-3 AUPs Supported by RX3i CPE305/CPE310 Embedded Ethernet
Interface
The default values and ranges of valid values are the same as those in other PACSystems Ethernet interfaces.
Note: When explicitly configuring speed or duplex mode for an RX3i embedded Ethernet port
using Advanced User Parameters (AUP), do not request a store to flash as a part of the
download when communicating over the CPE305/CPE310 embedded Ethernet port. In
this situation you first must store to the RX3i and then initiate a separate request to write
to flash.
System Memory Parameters (task b)
staudp
stpasswd
Backplane Driver Parameters (task c)
crsp_tout
chct_comp
cstorm
cnostorm
Ethernet Global Data Parameters (task g)
gctl_port
gdata_port
gbcast_ttl
gucast_ttl
gp_phase
gnostale
gXX_udp
gXX_addr
gXX_ttl
IP Parameters (task i)
ittl
ifrag_tmr
GFK-2224Q
e buffer size (in bytes)
1
Appendix A. Configuring Advanced User Parameters
January 2017
Default Range
1 0, 1
(1H)
240
1 − 65535 (ffffH)
(4.0 min)
2
0 − 65535 (ffffH)
60
1 − 65535 (ffffH)
seconds
65535
0 − 65535 (ffffH)
(ffffH)
4096
0 − 32767 (7fffH)
(1000H)
261