GE RX3i User Manual page 268

ARP Parameters (task f)
Interval in seconds at which to flush the ARP cache
fflush
Ethernet Global Data Parameters
gctl_port UDP port for EGD control messages
gdata_port UDP port for point-to-point (unicast) EGD messages
gbcast_ttl IP time-to-live for global broadcast messages (hop
count)
gucast_ttl IP time-to-live for point-to-point (unicast) messages
(hop count)
gp_phase Startup delay time in ms for successive produced
exchanges
gcmd_pri EGD command processing priority relative to data
production.
0 = EGD commands have lower priority.
1 = EGD commands have equal priority.
2 = EGD commands have higher priority.
gc_accel Enable consumed exchange acceleration.
0= Acceleration disabled; 1= Acceleration enabled.
Effective with RX3i CPE310/CPE305 Firmware Release 8.30, all EGD commands are supported except
27
gcmd_pri and gc_accel.
GFK-2224Q
(task g)
27
January 2017
Appendix A. Configuring Advanced User Parameters
Default
600 (10 minutes)
Default
7937 (1f01H)
18246 (4746H)
1 (1H)
16 (10H)
0 (0H)
0 (0H)
1 (1H)
Range
0 – 604800 (93A80H)
Range
1 – 65535 (ffffH)
Only the gdata_port
and gXX_udp
parameters may
share the same UDP
port number. All other
UDP port number
parameters in the AUP
file must use unique
port numbers.
1 – 65535 (ffffH)
Only the gdata_port
and gXX_udp
parameters may
share the same UDP
port number. All other
UDP port number
parameters in the AUP
file must use unique
port numbers.
0 – 255 (00ffH)
0 – 255 (00ffH)
0 – 65535 (ffffH)
0, 1, 2
0, 1
255