Minor Error Codes For Major Error Code 11H (At Remote Server Plc) - GE RX3i User Manual

Chapter 12. Diagnostics
Error Status (Hexadecimal)
Remote
Client
Server
FC05H FC85H
FE05H FE85H
FF05H FF85H

Minor Error Codes for Major Error Code 11H (at Remote Server PLC)

Error Status (Hex) SRTP Error Code Description
0111H Generic SRTP error.
0211H The PLC is inaccessible.
0311H Reserved.
0411H Unexpected SRTP version encountered in received message.
0511H Unrecognized SRTP message received.
0611H Data present in SRTP message, which should not contain data.
0711H Generic resource problem detected.
0811H SRTP message encountered in inappropriate connection state.
0911H Generic refusal by backplane driver to handle request.
0A11H Recognized but unsupported SRTP message received.
0B11H Lost transaction in server.
0C11H Error sending SRTP PDU to the client PLC.
1411H Unable to allocate a text buffer from dual port memory.
1711H Invalid text length detected in a mailbox message.
1811H Invalid number of destinations detected in a mailbox message.
1911H Invalid source detected in a mailbox message.
1A11H Invalid slot number detected in a mailbox message.
1B11H Invalid rack number detected in a mailbox message.
1D11H Bad text buffer address in dual port memory.
2111H Unable to find control data required to send a mailbox message to the PLC.
2211H Timed out waiting for availability of mail communications with the PLC.
2311H Invalid task ID detected while attempting to send a mailbox message to the PLC.
2411H Unable to send mailbox message to PLC because the mail queue is full.
2611H Unable to communicate with PLC.
2711H Backplane driver not initialized or unable to acquire a dual port memory semaphore.
2A11H The backplane driver could not access the PLC.
2B11H Invalid binding on the message sent to the backplane driver.
2C11H The message could not be sent to its destination because the mailbox was not open.
2D11H The maximum number of transfers to the destination is already taking place.
2E11H The maximum number of transfers of this transfer type is already taking place.
2F11H Cannot obtain a backplane transfer buffer.
3011H Cannot obtain resources other than backplane transfer buffers.
3111H Connection ID or block transfer ID is not valid.
3211H Timed out waiting for PLC CPU response.
3311H The PLC CPU aborted the request.
3411H An invalid message type was specified.
3511H The specified task is not registered.
224 PACSystems* RX7i & RX3i TCP/IP Ethernet Communications User Manual
Minor Error Code Description
I/O configuration is invalid.
No privilege for attempted operation.
Service request has been aborted.
GFK-2224Q