Led Indicators - Lennox iComfort E30 Installation And Setup Manual

7. Drill 3/16" (5 mm) holes at marked locations on the wall for anchors. Then insert
wall anchors into holes until flush with the wall.
Drill Holes
8. Secure mag-mount to wall or through wall-plate to wall with provided #6 x 1.25"
pan head screws (4). Connect thermostat wiring and reinstall access cover.
DO NOT over-tighten mounting screws. Doing so my distort the mag-mount
plastic housing and cause connection issues when installed the HD display.
9. Reinstall access cover.
MAG-MOUNT WITHOUT
ACCESS COVER
ACCESS
COVER
WHEN REINSTALLING
ACCESS COVER MAKE SURE THAT IT
IS SEATED PROPERLY. NOT DOING
SO WILL CAUSE CONNECTION
ISSUES.
NOTE: Make sure the Mag-Mount cover is reinstalled correctly to the Mag-Mount
base. The cover must be flush with the base or could cause power or
communication issues.
Insert in hole until ush with wall
WARNING
WALL PLATE (USE IS
OPTIONAL)
lED i
nDiCators
1. A blue LED is visible on the front of the Mag-Mount when it is connected,
powered up, and the HD Display has not been installed (see figure below) or
through the top vent of the mag-mount near the top-left corner when the HD
Display is installed.
Blue LED is visible here when Mag-Mount is
properly connected, power-on and HD Display
is not installed.
2. The LED has three conditions, steady on, flashing and off. Those conditions
are:
• Steady On - Mag-Mount is receiving power from the Smart Hub but not
connected to the HD Display.
Flashing - Mag-Mount is receiving power from the Smart Hub but could be
•
experiencing one of the following conditions:
The COMM BUS wires are disconnected or are shorted together.
»
» There has been a software error in the Mag-Mount processor.
There has been an internal hardware error in the Mag-Mount.
»
Connection is mis-wired.
»
• Off - Mag-Mount is not receiving power from the Smart Hub or there has
been a serious Mag-Mount internal hardware/software failure or the blue
LED is also off when an HD Display has been installed.
9
Blue LED is also visible through Mag-Mount to
NOTE: Blue LED is only ON when Mag-Mount a
contact.