Diagnostics; Installation Report; Information; Dehumidification Settings - Lennox iComfort E30 Installation And Setup Manual

D
iagnostiCs
This screen allows the installer to verify the current operational state of the air
handler or furnace. Diagnostics results are for active various inputs, voltage, delays
and relays.
Touch the left arrow at the top left side of screen to return to the Dealer Control
Center.
i r
nstallation Eport
• Overview: The overview screen provides information on dealer and customer
information. Also included under day of install section is information on conditions
at the time of installation. Information includes date, time indoor and outdoor
temperatures and indoor humidity.
• System: Information to complete is System name, model number and other
system information.
• Indoor Unit (air handler / furnace): name, model number, serial and other

information.

NOTE: Installation Report is not available until after exiting the dealer control
center following commissioning. Return to the Dealer Control Center from
the home screen to view the installation report.
i
nFormation
The dealer information screen will appear. The next screen will be for dealer
information. Here either the dealer ID or phone number can be added. Once the
system is connected to the Internet, the remaining information is automatically
populated. Not all information for this screen will be viewable. Touch and hold and
then swipe up to access the remaining information on the screen.
Information Required: Dealer ID and / or dealer phone number. Information that
can be manually entered is name, email website, dealer address which includes
address 1, address 2, city state and zip/postal code. Once completed, touch the left
arrow at the top left side of screen to return to the Dealer Control Center.
IMPORTANT
Adding dealer information will ensure the thermostat is associated with your
LennoxPROS.com account when connecting to the Lennox server.
Warning Screen: If the dealer ID or phone number is not provided, a warning screen
will appear. The warning screen will provided information on the limitation imposed
on the system if this information is missing. Touch no to return to the above screen
to complete the information requested or press yes to continue.
On this screen general information needs to be verified or changed. Touch any item
to change its contents. A pop-up screen will appear that will allow the information to
be added or changed.
Information Required:
1. Select desired language (ENGLISH, FRANÇAIS, ESPAÑOL).
2. Select country / region.
3. Select time and date which includes time, date, time zone, daylight savings
time (ON/OFF)
NOTE: When connected to INTERNET, then time and date can not be changed. If
the time and date is incorrect then turn off Wi-Fi and correct then turn Wi-Fi
back on.
4. Temperature unit (Fahrenheit or Celsius).
5. Once completed press continue.
On this screen general information needs to be verified or changed. Touch any line
item to change its contents. Information to be added is address 1, address 2, state,
city and zip/postal code.
Complete the requested information and press the continue button.

Dehumidification Settings

All controls for dehumidification under menu > settings > humidity. Under Humidity
Control, select dehumidify to enable dehumidification. By default it is disabled.
When dehumidify is enabled, the options are as follows and are dependent on
equipment type and accessory installed.
D s o
EhumiDiFiCation Etting ptions
• Normal — Recommend when the air outside is not too humid.
• Max — Single and Two-Stage Outdoor Units units without a Discharge Air
Temperature Sensor (DATS) Installed. Recommend when outdoor air is
excessively humid. May cool your home below the set temperature.
D s p
EhumiDiFiCation Et oint
Slide bar adjust with a range of 40% to 60%.
29
General Information
Home Address