Alternative Method; Multiple Smart Hub(S); Rebooting Smart Hub; Commissioning (Using The Hd Display) - Lennox iComfort E30 Installation And Setup Manual

4. If this is the first time connecting to the target Smart Hub then go to your mobile
device's Wi-Fi connection tool and locate the Smart Hub Wi-Fi broadcast
identifier. A typical example of a identifier (SSID) is DIRECT-XY12-3456.
5. If your mobile device had already connected previously to the target Smart
Hub, then touch the applicable Smart Hub SSID on the list and skip to step 7.
NOTE: Refer to your mobile device's owners manual on how to use your Wi-Fi
Connection tool.
6. Connect to the Smart Hub by using the last eight digits of the Smart Hub SSID
as the password (XY123456) for example.
7. Once connected to the mobile device the Smart Hub commissioning LED will
turn solid green.
8. Start the iComfort Mobile Setup application and make sure you are connected
to the correct Smart Hub by checking the serial number.
9. Touch the remote-in tab on the iComfort Mobile Setup application home
screen.
10. If the system has not been commissioned it will launch the commissioning
screen. If the system has already been commissioned it will go to dealer
control center.
11. Once servicing is completed, exit the iComfort Mobile Setup application.
12. Go to the mobile device's Wi-Fi tool and manually disconnect from the Smart
Hub.
13. Once disconnected the Smart Hub LED will change to a solid blue.
a m
ltErnativE EthoD
From the home screen, go to menu > settings > advanced settings > pair Smart
Hub to iComfort dealer mobile application selection. It will auto connect to dealer
application and start you at the dealer control center screen. The following screen
will appear and show the status of the connection. Once connected the screen will
automatically disappear.
Figure 13. Pairing
m s h ( )
ultiplE mart uB s
Multiple Smart Hubs in a home can be assigned to a group (up to nine groups with
up to eight Smart Hubs in each group). All Smart Hubs in a group can communicate
with other Smart Hubs in the same group over the home Wi-Fi network.
Default is Group ID is 1. Range is 0 to 9.
For example, seven Smart Hubs in a home can be divided up for example as 1 in
Group 1 and six in Group 2 or 4 in Group 1 and 3 in Group 2. Smart Hubs in Group
1 will not be able to see or interact with the Smart Hubs in Group 2. This allows the
intentional isolation of the Smart Hub for the master bedroom from the Smart Hub
for the children's area, for example.
If a Smart Hub is set to Group 0, there will be no connectivity with another Smart
Hub.
r s h
EBooting mart uB
Pressing the Smart Hub button for more than five seconds will reboot the Smart
Hub.

Commissioning (Using the HD Display)

The following procedures are written for the installer setup using the HD display.
When power is applied the system will use the smart hub configured equipment
settings and factory defaults. All non-communicating equipment must be added in
the "add non-communication equipment" screen.
B - s
oot up CrEEn
When power is applied to the system, the HD Display or sometimes referred
to as thermostat will display a welcome screen. For the iComfort Mobile Setup
application, refer to page 14 for establishing a wireless connection between the
iComfort Mobile Setup application and Smart Hub.
If there is an issue with communication between any component attached to the
thermostat, a critical alert message will appear on the screen. The alert message
will provide detail information concerning the possible cause. Once the issue is
corrected and power is restored to the system the first screen in the initial setup
sequence will appear. Below is an example of a communication error message.
19