Hd Display Components And Installation; Installation; External Components; Connecting Low Voltage Wiring - Lennox iComfort E30 Installation And Setup Manual

HD Display Components and Installation

i
nstallation
NOTE: Do not install HD Display or Mag-Mount on outside walls or in direct sunlight.
1. Hold the HD Display by the edges, line it up with the Mag-Mount, and move the
HD Display toward the Mag-Mount.
2. When the magnets in the Mag-Mount attract the HD Display, guide it toward the
Mag-Mount and let the magnets pull it into place. Press on the sides of the HD
Display to make sure it is completely seated on the Mag-Mount.
3. To remove the HD Display from the Mag-Mount, rotate the HD Display right
or left (clockwise or counter-clockwise) at least 30 degrees to disengage the
plastic hooks and then pull it straight off of the Mag-Mount. Failure to rotate
the HD Display before pulling it off of the Mag-Mount may loosen the dry wall
anchors or pull the Mag-Mount off of the wall due to the increased forced
required to separate the HD Display from the Mag-Mount when it is not rotated.
NOTE: If the HD Display is removed from the Mag-Mount base, the HD Display will
shut down and not be able to communicate with the system. System can
be controlled from mobile devices or dealer web portal once registration
has been completed.
4. Do not remove the protective film covering the HD Display screen until after
power is applied to the system.
CAUTION
1) Battery may need to charge before operation. Once the display
is connected, instructions may appear within 15 seconds with
further detail.
2) TO AVOID BREAKING THE GLASS DISPLAY
a. Do not apply force directly to the glass display
b. Holding the display horizontally
i. Center the display cavity on the base
ii. Press both sides equally until the snaps engage
3) AVOID EXCESSIVE FORCE TO THE CLASS DISPLAY
E C
xtErnal omponEnts
• Proximity Sensor - Detects a person approaching the HD Display. If the HD
Display is in Screen Saver mode and the Proximity Detect feature is set to ON,
the proximity sensor takes the HD Display out of screen saver mode and returns
the home screen when someone approaches.
• Power Button - Resets the HD Display when pressed and held for about 5
seconds.
• Micro-SD Card Connector - Not functional, for future use
• USB Connector - Not functional, for future use
• Speaker - Not functional, for future use
Figure 5. HD Display Components

Connecting Low Voltage Wiring

The following diagrams illustrated the basic Lennox communication control wiring
for all compatible components.
D a t s
isChargE ir EmpEraturE Ensor
• Installation of discharge air temperature sensor (DATS) (88K38) must comply
with the following requirements:
• Installed downstream of the heat exchanger or electric heat elements.
• It must be placed in free airflow, where other accessories (such as humidifiers,
UV lights, etc.) will not interfere with its accuracy.
10
(Dats)