Mag-Mount Led And Installation; Installation - Lennox iComfort E30 Installation And Setup Manual

Mag-Mount LED and Installation

Magnets located in this product have far-reaching and strong magnetic fields.
They could damage TVs and laptops, computer hard drives, credit and ATM
cards, data storage media, mechanical watches, hearing aids and speakers.
Keep HD Display and Mag-Mount away from devices and objects that could be
damaged by strong magnetic fields.
i
nstallation
Unpack the HD Display and Mag-Mount (wall base). Install Mag-Mount in desired
location away from direct sunlight or any discharge vents. Use the following
procedure:
1. Cut or drill a small hole for thermostat wiring.
2. Pull about three inches of thermostat wire through the opening and remove the
outer thermostat wire jacket.
Seal wire hole in wall to prevent
cold or hot air from a ecting temperature
IMPORTANT
Seal wire hole in wall to prevent cold or hot air from affecting temperature sensor
in HD Display.
3. Strip 1/4" (7 mm) insulation from end of each wire.
CAUTION
3/8" (10 mm)
Diameter Hole
sensor in display
1/4"
4. Use a level to align either the mag-mount or wall plate on wall horizontally.
5. Remove cover from mag-mount by inserting a flat-head screwdriver into the
slot on each side of the mag-mount. Give it a gentle twist to separate the two
sections.
Slot
6.
Use mag-mount as a template to mark the desired mounting hole locations on
the wall.
8
Slot
Use either the Mag-Mount or wall
plate as a template to mark the
desired mounting hole locations
on the wall.