Table of Contents
Advertisement
November 29, 1999
6.9.6 OPTIONAL G3 UNIT MODEM PROGRAM DOWMLOAD (IC
CARD TO MACHINE)
This updates the optional G3 unit modem program (downloads it from an IC card).
1. After turning off the main power, insert the IC card containing the modem
program into the IC card slot on the front of the machine (left side).
NOTE: The FCU switch must be off.
2. Turn on the power and select "6. SG3 MDM" and press START.
NOTE: The LCD display should be "FLASH ROM → MACHINE".
3. If "OK" is displayed, exit the function and turn the power off.
If "NG!!" is displayed, repeat from step 2.
4. Remove the IC card, insert the function upgrade card or FOD card (if it was
installed), and replace the cover.
5. After turning the power back on, print out the system parameter list and check
that the program has been successfully downloaded.
6.9.7 G4 UNIT PROGRAM DOWNLOAD (IC CARD TO MACHINE)
This updates the G4 unit program in the machine (downloads it from an IC card).
1. After turning off the main power, insert the IC card containing the G4 unit
program into the IC card slot on the front of the machine (left side).
NOTE: The FCU switch must be off.
2. Turn on the power and select "7. SIG4 ROM" and press START.
NOTE: The LCD display should be "FLASH ROM → MACHINE".
3. If "OK" is displayed, exit the function and turn the power off.
If "NG!!" is displayed, repeat from step 2.
4. Remove the IC card, insert the function upgrade card or FOD card (if it was
installed), and replace the cover.
5. After turning the power back on, print out the system parameter list
and check that the program has been successfully downloaded.
DATA AND FIRMWARE DOWNLOAD/UPLOAD
6-43
Advertisement
Table of Contents
