Table of Contents
Advertisement
November 29, 1999
6.6.4 REPLACING THE PAPER EXIT SENSOR
[B]
1. Remove the upper cover (2 screws). (See section 6.1.4.)
2. Remove the operation panel (3 screws, 1 connector, 1 ground wire). (See
section 6.1.4.)
3. Pull out the paper cassette and remove the front cover (5 screws). (See section
6.1.4.)
4. Remove the connectors of the paper exit sensor.
5. While holding up the actuator [A] of the paper exit sensor, release the front
pawl and remove the paper exit sensor [B].
NOTE: This procedure is easier to perform if the optical unit is first removed.
(See section 6.2.6)
[A]
H306R905.WMF
6-25
SENSORS
Advertisement
Table of Contents
