Table of Contents
Advertisement
November 29, 1999
6.9 DATA AND FIRMWARE DOWNLOAD/UPLOAD
ø
CAUTION
1. Make sure to turn the power off before inserting the IC card.
2. If the function expansion card or FOD card was installed, make sure to
re-install it before turning the power on. Otherwise programmed data
may be lost.
Preparation
For all firmware for this model (with or without options installed), the start address
should be set to 200000 when preparing the IC card with the "SwapFTL" utility.
6.9.1 FCU PROGRAM DOWNLOAD (IC CARD TO MACHINE)
This downloads the FCU program from the IC
card to the machine.
1. After turning off the main power, insert the
IC card containing the program into the IC
card slot on the front of the machine (left
side).
NOTE: The FCU switch must be on.
2. Turn on the power and select "1. ROM
(ROM → MACHINE)" and press START.
NOTE: The LCD display should be "FLASH
ROM → MACHINE".
3. If "OK" is displayed, exit the function and
turn the power off.
If "NG!!" is displayed, repeat from step 2.
4. Put the FCU switch back to OFF.
5. Remove the IC card, insert the function upgrade card or FOD card (if it was
installed), and replace the cover
6. After turning the power back on, print out the system parameter list and confirm
the ROM version, date, and suffix.
DATA AND FIRMWARE DOWNLOAD/UPLOAD
6-39
H306R500.WMF
Advertisement
Table of Contents
