Table of Contents
Advertisement
November 29, 1999
4.1.29 OPTIONAL SG3 BOARD NCU PARAMETERS (FUNCTION
18)
These parameters are for the optional G3 NCU. The parameters are similar to the
standard NCU parameters (Function 08), but they are kept separate. This allows
the two NCUs to have different settings.
ë
1. î
then immediately
within 3 seconds
ì å
2.
ë
3.
í
4.
5. Scroll through the parameters using
? or @ . If you want to change a value,
enter the new value at the keypad,
then press # .
6. To finish # î.
NOTE: 1) Parameter CC is the Country Code, Parameter 01 is the Tx level.
2) If you change the NCU country code and exit the service mode, the
bit switch country code (System Bit Switch 0F) will not be changed
(compare this with the NCU country code for the standard NCU –
see Function 08).
ì ä ä å
4
4-15
SERVICE LEVEL FUNCTIONS
H306M501.BMP
H551M545.BMP
H551M548.BMP
H306M549.BMP
Advertisement
Table of Contents
