Table of Contents
Advertisement
November 29, 1999
4.2.5 G3 SWITCHES
G3 Switch 00
No
FUNCTION
0
Monitor speaker during
communication (TX and RX)
1
Bit 1 Bit 0
Setting
0
0
0
1
1
0
1
1
2
Monitor speaker during
memory transmission
0: Disabled 1: Enabled
3-7 Not used
G3 Switch 01
No
FUNCTION
0-3 Not used
4
DIS frame length
0: No limit
1: 4 bytes
5
Not used
6
CED/ANSam transmission
0: Enabled
1: Disabled
7
Not used
G3 Switch 02
No
FUNCTION
0
G3 protocol mode used
0: Standard and non-standard
1: Standard only
1-4 Not used
5
Use of modem rate history
when dialing using
Quick/Speed dials
0: Disabled
1: Enabled
6
AI short protocol (transmission
and reception)
0: Disabled 1: Enabled
7
Not used
(0, 0): The monitor speaker is not in use
throughout communication.
(0, 1): The monitor speaker is on up to phase B
Disabled
in the T.30 protocol.
Up to Phase B
(1, 0): Used for testing. The monitor speaker is
All the time
on throughout communication.
Not used
Make sure that you reset these bits after testing.
1: The monitor speaker is in use during memory
transmission.
Do not change these settings.
Do not change these settings.
1: Only the first 4 bytes in the DIS frame will
transmit (set to 1 if there are communication
problems with PC-based faxes, which cannot
receive extended DIS frames).
Do not change this setting.
Do not change this setting, unless a
communication problem is caused by sending
CED/ANSam (V.34).
Do not change this setting.
1: Disables NSF/NSS signals (these are in non-
standard mode communication).
Do not change these settings.
0: Communications using Quick/Speed dials
always start with the highest modem rate.
1: The machine uses the modem rate history for
communications with the same machine when
determining the most suitable rate for the
current communication.
Refer to Appendix B in the Group 3 Facsimile
Manual for details about AI Short Protocol.
Do not change these settings.
COMMENTS
COMMENTS
COMMENTS
4-51
BIT SWITCHES
Advertisement
Table of Contents
