Bit Switches; System Switches - Aficio 5000L Service Manual

BIT SWITCHES

4.2 BIT SWITCHES
ø
WARNING
Do not adjust bit switches described as "Not used", as this may cause the machine to
malfunction or to operate in a manner that is unacceptable under local regulations. Such
bits are only for use in other areas, such as Japan.
NOTE: This manual does not list default settings for bit switches. Refer to the
System Parameter List.
The switches that have been changed from the previous model (FR4) are
shaded.

4.2.1 SYSTEM SWITCHES

System Switch 00
No
RAM Reset
Bit 1 Bit 0 Reset Level
0 0
0 1
1 0
1 1
0
1
FUNCTION
No reset
Reset Level 2
Reset Level 3
Not used
COMMENTS
Reset Level 3: Erases all image data files
stored in the SAF memory and
communication files (e.g. substitute RX
files). This is the recommended setting
when the SAF requires clearing.
Reset Level 2: This level erases the
following items in addition to those erased
by Reset Level 3: own telephone number,
bit switches (excluding country code),
RTI/TTI/CSI, report data, programmed
telephone numbers (Quick/Speed/Groups,
service station, etc.), NCU parameters. The
NCU country code is also set to the same
as the bit switch country code (System Bit
Switch 0F).
After erasing, the machine automatically
changes these two bits back to 0.
No reset: Normal operation
Cross-reference
RAM Reset Level 1 (Factory reset):
Change the RAM address data from
480005(H) to FF(H), then turn the machine
off and on. In addition to those items erased
by Reset Level 2, the clock, country code
(the default country code is UK), scan
margin settings, and print registration
settings are erased.
4-20
November 29, 1999