G3-2 Switches - Aficio 5000L Service Manual

BIT SWITCHES

4.2.6 G3-2 SWITCHES

These bit switches require an optional G3 interface unit.
G3-2 Switch 00 - Not used (do not change any of these settings)
G3-2 Switch 01
No FUNCTION
0-3 Not used
4 DIS frame length
0: No limit
1: 4 bytes
5 Not used
6 CED/ANSam transmission
0: Enabled
1: Disabled
7 Not used
G3-2 Switch 02
No FUNCTION
0 G3 protocol mode used
0: Standard and non-standard
1: Standard only
1-4 Not used
5 Use of modem rate history
when dialing using
Quick/Speed dials
0: Disabled
1: Enabled
6
AI short protocol (transmission
and reception)
0: Disabled 1: Enabled
7 Not used
COMMENTS
Do not change these settings.
1: Only the first 4 bytes in the DIS frame will
transmit (set to 1 if there are communication
problems with PC-based faxes, which cannot
receive extended DIS frames).
Do not change this setting.
Do not change this settings, unless a
communication problem is caused by sending
CED/ANSam (V.34).
Do not change this setting.
COMMENTS
1: Disables NSF/NSS signals (these are in non-
standard mode communication).
Do not change these settings.
0: Communications using Quick/Speed dials
always start with the highest modem rate.
1: The machine uses the modem rate history for
communications with the same machine when
determining the most suitable rate for the
current communication.
Refer to Appendix B in the Group 3 Facsimile
Manual for details about AI Short Protocol.
Do not change these settings.
4-58
November 29, 1999