3.6
ABORTING A PROGRAM
The operator may abort (i.e. terminate) the current program by holding down the
Run/Hold key for more than five seconds. When the program is aborted, a return is
made to the Base Mode and the Message Display will show:
This message will be removed by the next keypress.
3.7
"END OF PROGRAM" INDICATION
When the program has reached its End Marker, the Message Display shows:
and a return is made to Base Mode.
3.8
VIEWING PROGRAM AND CONTROLLER PARAMETERS
In Program Run Mode (i.e. with a program currently running or held), the MODE
key gives "view only" access to Program Define Mode and Controller Define
Mode:
VIEW ONLY
See Section 8
VIEW ONLY
See Section 9
3-3