Manual Control - Honeywell dcp100t Operator's Manual

7

MANUAL CONTROL

In any mode except Configuration Mode or Calibration Mode, the operator may
select manual control of the process by simultaneously pressing the SET UP and
MODE keys. The Digital Controller Programmer will then enter Base Mode or (if a
program is currently running) Program Run Mode with the program held. The
Message Display will show:
and the lower Main Display will show the power output value, which may then be
adjusted using the Up and Down keys. Whilst manual control is being exercised,
the power output display is included in the displays available in Base Mode and
Program Run Mode.
To cancel manual control, press the SET UP and MODE keys simultaneously,
whereupon the power out value display and the Power Message Display will
disappear and the Digital Controller Programmer will remain in whatever mode
prevailed when manual control was cancelled (if this is Program Run Mode, the
currently-running program will be resumed from the point at which it was held).
7-1