De Fin Ing The Con Trol Ler Pa Rame Ters (Con Trol Ler De Fine Mode) - Honeywell dcp100t Operator's Manual

9 DEFINING THE CONTROLLER
PARAMETERS
(CONTROLLER DEFINE MODE)
Entry can be made into this mode from Program Define Mode, Program Run
Mode or Base Mode.
To enter from Base Mode or Program Run Mode:
1. Press the SET UP and Up keys si mul ta ne ously. The lower Main Dis play will
show 0 and the Mes sage Dis play will show:
2. Use the Up and Down keys to set the value in the lower Main Dis play to
the cor rect Lock Code Value (for Program De fine Mode) and press the SET
UP key. The Digi tal Con trol ler Pro gram mer is now in Pro gram De fine Mode.
NOTE: If an in cor rect Lock Code Value is en tered, the Digi tal Con trol ler
Pro gram mer will re turn to its origi nal mode (i.e. Base Mode or Pro gram Run
Mode).
3. Press the MODE key. If the instrument has been configured to have only
one Lock Code, entry into Controller Define Mode is immediate and no
further action is needed. If the instrument is configured to have two Lock
Codes (one for Program Define Mode, one for Controller Define Mode), the
Lower Main Display will show 0 and the Message Display will show:
4. Use the Up and Down keys to set the value in the Lower Main Display to
the Lock Code value (for Controller Define Mode), then press the SET UP
key.
The Digital Controller Programmer is now in Controller Define Mode.
NOTE: If an in cor rect Lock Code Value is en tered, the Digi tal
Con trol ler Pro gram mer will re turn to its origi nal mode (i.e. Base
Mode, Pro gram Run Mode or Program Define Mode).
To enter from Program Define Mode, perform Step 3 and (if necessary) Step 4
above.
9-1