Blind Transfer - Yealink SIP-T27P User Manual

User Guide for the SIP-T27P IP Phone
To enable allow trans exist call via web user interface:
Click on Features->General Information.
1.
Select Enabled from the pull-down list of Allow Trans Exist Call.
2.
Click Confirm to accept the change.
3.

Blind Transfer

Before performing a blind transfer (except you use dial number method), make sure that the
transfer mode on DSS key is configured as Blind Transfer. For more information on how to
configure it, refer to
To perform a blind transfer during a call:
Press
1.
You can do one of the following:
2.
Enter the number you want to transfer the call to.
-
116
Configuring Transfer Mode on DSS Key
or the Transfer soft key during a call.
on page 142.