Message Waiting Indicator (Mwi) - Yealink SIP-T27P User Manual

To listen to voice mails:
When the LCD screen prompts that the phone receives a new voice mail and the power
1.
indicator LED slowly flashes red, you can press
voice mail access code.
Follow the voice prompt to listen to your voice mails.
2.
Before listening to voice mails, make sure the voice mail access code has been configured.
Note
When all new voice mails are retrieved, the power indicator LED will go out.
To view the voice mail via phone user interface:
Press Menu->Messages->Voice Mail->View Voice Mail.
1.
The LCD screen displays the amount of new and old voice mails.
Select an account and then press the Connect soft key to listen to voice mails.
2.

Message Waiting Indicator (MWI)

The SIP-T27P IP phone supports MWI when receiving a new voice message. If someone leaves
you a voice mail, you will receive a message waiting indicator. MWI will be indicated in three
ways: a warning tone, an indicator message (including a voice mail icon) on the LCD screen, and
the power indicator LED slowly flashes red. This will be cleared when you retrieve all voice mails
or delete them.
The MWI service is unsolicited for some servers, so the SIP-T27P IP phone only handles the MWI
messages sent from the server. But for other servers, the MWI service is solicited, so the
SIP-T27P IP phone must enable subscription for MWI.
Note MWI service is not available on all servers. Contact your system administrator for more
information.
Advanced Phone Features
or the Connect soft key to dial out the
187