Yealink SIP-T27P User Manual page 155

To place a call to the monitored user when the IP phone is idle:
Press the BLF key.
1.
The IP phone dials out the phone number of the monitored user.
Transferring a Call to the Monitored User
When there is already an active call on the IP phone, you can transfer the active call to the
monitored user by pressing the BLF key. The phone handles the active call differently depending
on the configuration of transfer mode via Dsskey with the BLF key (refer to
Mode on DSS Key). The transfer mode on DSS key has the following modes:
Blind Transfer

Attended Transfer

New Call

When the transfer mode on DSS key is set to Blind Transfer and there is already an active call
on the IP phone, you can do the following:
To perform a blind transfer:
Press the BLF key of the monitored user which you want to transfer this call to.
1.
Then the active call is connected to the number of the monitored user.
When the transfer mode on DSS key is set to Attended Transfer and there is already an active
call on the IP phone, you can do the following:
To perform a semi-attended transfer:
Press the BLF key of the monitored user which you want to transfer this call to. The phone
1.
will dial the number of the monitored user.
Press the BLF key of the monitored user again or the Transfer soft key to complete the
2.
transfer when receiving ringback.
To perform an attended transfer:
Press the BLF key of the monitored user which you want to transfer this call to. The phone
1.
will dial the number of the monitored user.
Press the BLF key of the monitored user again or the Transfer soft key to complete the
2.
transfer after the monitored user answers the call.
When the transfer mode on DSS key is set to New Call and there is already an active call on the
IP phone, you can do the following:
To perform a new call:
Press the BLF key of the monitored user you want to call.
1.
The phone will dial the number of the monitored user. The original call is placed on hold.
Advanced Phone Features
Configuring Transfer
143