Downloading Nvram Data - Ricoh J-P3 Service Manual

FIRMWARE UPDATE

Downloading NVRAM Data

Copy the data from the SD card to the NVRAM (referred to as "to download
NVRAM data" in this section) after you replace the NVRAM. If you cannot
download NVRAM data, manually input the necessary settings.
1. Make sure that the main power switch is off. If it is on, turn it off.
2. Make sure that you have the correct SD card that contains the necessary
NVRAM data.
3. Insert the SD card into slot 1.
4. Turn on the main power switch.
5. Start the SP mode.
6. Select SP5-825 (NVRAM Download).
7. Push the enter key. The download starts.
NOTE: The machine cannot do the download if the file name in the SD card is
different from the serial number of the printer (☛Uploading NVRAM
Data).
8. Go out of the SP mode.
9. Turn off the main power switch.
10. Remove the SD card.
11. Turn on the main power switch.
12. Check that the NVRAM data is correctly downloaded.
This procedure does not download the following data to the NVRAM:
• Total Count
• Machine's Device Number
5-80
20 February 2004