Ricoh J-P3 Service Manual page 121

20 February 2004
2916 009 [FC M] 600
2916 010 [FC C] 600
2919 [MScan Lgth Det] Main-
scan Length Detection
Enables or disables the main-scan length detection.
2994 [MScan Reg Cor] Main-scan Registration Correction ([Color])
Not used. DFU
2994 001 [Y]
2994 002 [M]
2994 003 [C]
2994 004 [K]
2995 [Motor Reset] Mirror Positioning Motor Reset
Rotates the mirror position motors (CMY) by 250 pulses clockwise; then by 125
pulses counterclockwise. This moves the mirrors back to the initial position. Then,
the settings of SP2-908-002 to 004 are reset to 0.
When the line position adjustment fails, it is one of possible causes when the mirror
position motor locks. Performing this SP mode can move the mirrors back to the
original position if it locks. Then, do the forced line position adjustment (SP5-993-
002).
*BCU [0 to 20000 / 568 / 1 dot] DFU
*BCU [0 to 20000 / 2881 / 1 dot] DFU
*BCU [0 or 1 / 1 / -] Alphanumeric
0: Disable
1: Enable
*BCU [-128 to 127 / 0 / 1 dot/step] DFU
*BCU [-128 to 127 / 1 / 1 dot/step] DFU
*BCU [-128 to 127 / 1 / 1 dot/step] DFU
*BCU [-128 to 127 / 0 / 1 dot/step] DFU
*BCU
5-25
ENGINE SERVICE MODE