Adjusting The Height - Ricoh J-P3 Service Manual

20 February 2004

Adjusting the Height

1. Check the type of the optional paper tray:
• If the optional two-tray paper feed unit or the optional LCT is installed, go to
step 2.
• If either of them is not installed, go to "Main Body."
2. Tape the pads [A] to the right-hand side of the machine.
3. Lay the machine on its right-hand side.
4. Remove the adjuster plates [B] (! x 2).
5. Change the height [C].
6. Reinstall the adjuster plates [D].
7. Take out the machine from the box and stand it up.
8. Check that the height is correct, and remove the pads.
[B]
[A]
G106I933.WMF
1-23
OPTIONAL UNIT
[D]
[C]
G106I934.WMF