Transfer And Paper Transport Unit; Transfer Unit - Ricoh J-P3 Service Manual

20 February 2004

3.5 TRANSFER AND PAPER TRANSPORT UNIT

3.5.1 TRANSFER UNIT

NOTE: When removing or installing the transfer unit, grasp the grip on the front
frame and the center of the rear frame. Do not touch the transfer belt [A].
Do not damage the entrance Mylar [B].
[A]
[C]
1. Turn the release lever counterclockwise (☛ [P2] 3.5).
2. Pull out the transfer unit [C] until the entire unit is visible (! x 2).
3. Grasp the handle on the front frame and the center of the rear frame, and lift
the unit to remove it.
After replacing the transfer unit:
• Reset the maintenance counter, SP7-804-017
• Remove all the PCUs.
• Do the transfer belt idling with SP5-804-066 for 1 minute.
• Install the PCUs.
• Perform forced line position adjustment (SP5-993-002 or Menu > Maintenance >
Color Regist. > Auto Adjust).
• Print the 1-dot grid pattern on A3/11" x 17" paper and check the color shift level
(☛ [P2] 4.4.3).
TRANSFER AND PAPER TRANSPORT UNIT
3-11
[B]
G106R940.WMF