Preparing The Printer - Ricoh J-P3 Service Manual

PRINTER

Preparing the Printer

!
CAUTION
Make sure that the transfer belt is in its correct position before moving the
printer, otherwise the transfer belt and the black PCU may be damaged.
1. Check that the transfer belt is in its correct position.
2. Remove the supports (☛ 1.3.4).
3. Remove the toner bottles to prevent toner from flowing into the toner supply
tubes during transport. This may cause the tube to be clogged with toner.
4. Put air packing into the toner cartridge holders to shield the toner supply
entrances. This prevents toner from flowing out to the toner cartridge holders.
5. Set the lock pin [A] (which comes
with the machine) in the transfer
belt unit.
NOTE: The lower end of the
transfer belt moves. The
surfaces of the belt and
PCU may be damaged by
the friction between them if
you transport the machine
without locking the belt.
6. Make sure there is no paper left in the paper trays and fix down the bottom
plates with a sheet of paper and tape.
7. Empty out the waste toner bottle and attach securing tape to prevent the bottle
from coming out.
8. Empty out the waste oil bottle and attach securing tape to prevent the bottle
from coming out.
[A]
1-10
20 February 2004
G106I906.WMF