Ricoh J-P3 Service Manual page 133

20 February 2004
5828 [Network] Job spool settings/ Interface selection for Ethernet and wireless LAN
5828 066 HD job Clear
Treatment of the job when a spooled job exists at power on.
5828 069 Job Spool (Protocol)
Switches job spooling off or on and enables settings for job spooling protocols.
5828 074 Delete Password
5828 084 Print Settings List
5828 090 TELNET
Enables or disables Telnet.
5828 091 Web
Enables or disables the Web monitor.
5828 115 SMB Computer Name
Displays the SMB computer name.
5828 116 SMB Workgroup Name
Displays the workgroup name.
5832 [HDD Init.] HDD Initialization
Prepares the hard disk. Use this SP mode only when there is a hard disk error.
5833 [JobLog ON/OFF]
Saves the result of the jobs in the job log. If this mode is enabled, the result is
written on the HDD. If no HDD is installed, this feature is disabled even if this SP is
set to "enabled"..
5839 [IEEE1394]
5839 004 Device Name
5839 007 Cycle Master
5839 008 BCR mode
5839 009 IRM 1394a Check
5839 010 Unique ID
5839 011 Logout
5839 012 Login
5839 013 Login MAX
5840 [IEEE 802.11b]
5840 004 Current SSID
Enters a unique ID (up to 32 characters long) to identify the device when it is
operating in an area with another wireless LAN network.
*CTL [0 to 1 / 1 / 1/step]
0: Data is cleared
1: Automatically printed
*CTL [0 to 1 / 1 / 1/step]
0: Off, 1: On
Bit switch:
• Bit 0: LPR
• Bit 1: FPT
• Bit 2: IPP
• Bit 3: SMB
• Bits 4 to 7: Reserved
*CTL Deletes passwords.
*CTL Prints a list of NCS related parameters.
*CTL [0 to 1 / 1 / 1/step]
0: Disabled, 1: Enabled
*CTL [0 to 1 / 1 / 1/step]
0: Disabled, 1: Enabled
*CTL [0 or 1 / 0 / -]
0: Disabled, 1: Enabled
*CTL DFU
*CTL DFU
*CTL DFU
*CTL DFU
*CTL DFU
*CTL DFU
*CTL DFU
*CTL DFU
*CTL
5-37
ENGINE SERVICE MODE