Energetics A282 Manual page 6

Step 3
Step 4
1. Secure the Handle Bar (3) onto the Console
Mast (2) with the 2pcs of 5/16" x 5/8" Hex
Head Screws (51), 2pcs of 5/16" x 19 x 1.5T
Flat Washers (72) and 2pcs of 8m/m Split
Washers (103) by using the 12/14mm Wrench
(100).
2. Let the Handpulse W/Cable (26) through the
Console Plate onto the Console Mast (2) and
out from the Console Plate.
1. Insert the
Handlepulse W/Cabls (26) onto the Console
(34).
2. Secure the Console (34) onto the Front
Console Mast (2) with the 4pcs of M5 x 12mm
Phillips Head Screws (58) by using the Phillips
Head Screw Driver (93).
3. Secure the Front Stabilizer Cover (40) and the
Rear Stabilizer Cover (41) onto the Main Frame
(1) and the Rear Stabilizer (5) with the 4pcs of
M5 x 12m/m Phillips Head Screws (58) by
using the Phillips Head Screw Driver (93).
4. Install the Pedal (L)(R) (45)(46) onto the Crank
(L)(R) (16L)(16R)
Wrench (92).
5. Turn on the Locking Knob (106) and install the
Inner Slide Assembly (6) into the Outer Slide
(1).
6. Adjust the highly and tighten the Locking Knob
(106).
7. Turn on the Fore Aft Adjustment Knob (86)
and install the Seat Slide Bracket (7) put on the
Inner Slide Assembly (6).
8. Adjust the position and tighten the Fore Aft
Adjustment Knob (86).
9. Install the Seat Bottom Cushion on the Seat
Slide Bracket (7) by using the 12/14mm
Wrench
6
Computer Cable (29)
by using the13/15mm
and