Detaching And Refitting The Heat Roller Separation Claws - Kyocera KM-2560 Service Manual

Hide thumbs Also See for KM-2560:

Table of Contents

(2) Detaching and refitting the heat roller separation claws

Follow the procedure below to replace the heat roller separation claws.

1. Remove the fuser heater (see page 1-5-47).

2. Remove four screws.

3. Remove four claws and remove the rear

fuser guide.

4. Remove the spring and remove the heat

roller separation claws.

5. Replace the heat roller separation claws and

install the claws.

6. Refit all the removed parts.

Rear fuser guide

separation claw

Figure 1-5-81

Figure 1-5-82