Table of Contents
Advertisement
Curl Control
Thin paper has a tendency to jam or wrinkle, especially during duplex printing. When
this SP code is switched on:
• The machine ignores the fusing temperature set for SP1105.
1911
• When the machine is powered on or recovers from the low power mode the machine
requires about 20 sec. to warm up (this is longer than normal).
[0 or 1 / 0 / -]
0: No (Normal)
1: Yes (Curl Control)
SC559 Detect
This SP setting determines whether SC559 is issued after three paper late jams occur in
the fusing unit. After this SP code is turned on, a counter monitors the number of paper
late jams that occur in the fusing unit. After the 3rd occurrence of a fusing jam, SC559 is
issued and the machine cannot be used until the service technician releases the error.
1913
Note: Switching the machine off/on does not reset this jam counter. The counter is reset
after the cause of the jam has been removed and a sheet of paper successfully passes
the fusing exit sensor.
[0 to 1 / 0 / 1]
0: No
1: Yes
1914
Nip Measure (Fusing Nip Width Measurement)
Measure Exe.
1914 001
Performs the nip width measurement. This is for by-pass tray and used OHP type.
Envelope Flap
1915
JPN use only
SP2-xxx: Drum
Charge Rol Bias
2001
Adjusts the voltage applied to the charge roller for printing.
Curl Reduction
Fusing Jam SC Setting
-
-
SP Tables
3
31
Advertisement
Table of Contents
Troubleshooting
