Ricoh Kr-P2 Field Service Manual page 157

5821 2 RCG IP Address
NVRAM Upload
Uploads the UP and SP mode data (except for counters and the serial number) from
5824
NVRAM on the control board to a flash memory card.
While using this SP mode, always keep the front cover open. This prevents a software
module accessing the NVRAM during the upload.
NVRAM Download
5825
Downloads the content of a flash memory card to the NVRAM on the control board.
Network Setting
This machine supports both Internet Protocols IPv4 and IPv6. IPv6 is the next generation
5828
protocol designed by the IETF to replace IPV4. IPv6 adds many improvements such as
routing and network auto-configuration.
5828 050 1284 Compatible
5828 052 ECP
5828 065 Job Spooling
Sets the IP address of the RCG (Remote Communication
Gate) destination for call processing at the remote
service center.
[00000000h to FFFFFFFFh/00000000h/
Enables and disables bi-directional communication on the
parallel connection between the machine and a computer.
[0 to 1 / 1 / -]
0:Off, 1: On
Disables and enables the ECP feature (1284 Mode) for data
transfer.
[0 to 1 / 1 /-]
0: Disabled
1: Enabled
Switches job spooling spooling on and off.
0: No spooling, 1: Spooling enabled
SP Tables
3
59