Selecting The Rs-232C Baud Rate - Konica Minolta CA-310 Instruction Manual

2. Selecting the RS-232C Baud Rate

The RS-232C baud rate can be changed according to the setting made on the computer that is used for remote
measurement.
[Operating Procedure]
1
. Press the key.
The LCD display section will switch to the menu selection
screen.
2
. Press the key to open the RS232C baud rate
selection screen.
Each time the key is pressed, the screen will switch in the
order PROBE → SYNC → ID Name input → RANGE →
Measurement Speed → Number of Digits → Calibration Stan-
dard → RS232C Baud Rate → PROBE.
3
. Press the key until the desired baud rate ap-
pears.
Each time the key is pressed, the baud rate switches in
the order 38400 → 19200→ 9600 → 4800 → 2400 → 1200
→ 600 → 300 → 38400.
4
. Press the key to confirm the selection.
* By default (factory setting), the instrument is set so that [38400] will be selected automatically when the POWER switch is set to ON( | ).
* To cancel selection of RS-232C baud rate, press the
<Notes when Selecting the RS-232C Baud Rate>
● The specified RS-232C baud rate will be kept even if the POWER switch is set to OFF(O).
The selected RS-232C baud rate will be effective when the POWER switch is set to ON( | ).
<Reference>
Communication parameter setting (RS-232C)
Set the same communications settings as those on the instrument to the computer.
Baud rate: 38400 (factory setting), 19200, 9600, 4800, 2400, 1200, 600, 300, BPS
Start bit: 1 bit
Character length: 7 bits (ASCII code)
Parity check: EVEN
Stop bit: 2 bits
PQRS TUV WXYZ
1
7 8 9
MENU
GHI JKL MNO LOCK
4 5 6
ALPHA
White ABC DEF - SPACE
2
1 2 3
CAL
3
Red Green Blue
0 .
4
ENTER
key.
87
Menu selection screen
MENU : SELECT
PUSH SPACE KEY
RS-232C baud rate selection screen
SELECT : BAUD
38400
SELECT : BAUD
19200
SELECT : BAUD
9600
Press the
key until the
desired baud
rate appears.