Instrument Status At Power-On - Konica Minolta CA-310 Instruction Manual

2. Instrument Status at Power-ON

The instrument has been set prior to factory shipment so that it will be set as follows when the POWER switch is
set to ON.
1 Measurement mode
2 Memory channel no.
3 Target color
4 PROBE
5 SYNC mode
6 ID name
7 Analog display range value
8 Measurement speed
9 Number of display digits
10 Calibration standard
11 RS232C baud rate
12 Calibration data (stored) in CH00 to CH99 Page 51
13 Luminance unit
<Changing the Instrument Status at Power-ON>
Change necessary parameters and press the
whistling sound when the settings are saved. The instrument will start with the new settings when the power is
turned ON next time. (The selected mode and memory channel etc. will be stored in the instrument's memory, and
they will remain effective even if the POWER switch is set to OFF.)
Changing Method for parameters 1 and 2
1 Measurement mode .........Press the MODE key.
2 Memory channel .............Press the CH
Changing Method for parameter 3
3 Target color value ............The current target color will be changed if you
Page 40
Page 48
Page 63
Page 43
Page 36
Page 67
Page 69
Page 36
Page 42
Page 50
Page 87
Page 32
key for more than five seconds. A bleep will sound, followed by a
and
select a mode other than flicker and then enter a
target color, or select user calibration or enter
the RGB emission characteristic for analyzer
mode.
xyLv mode
CH00
x = 0.3127 y = 0.3293 Lv = 160.0 (cd/m
P1
EXT mode
Consists of Blank spaces only.
10% (all ranges)
AUTO
4 digits
6500K Konica Minolta's standard data
38400bps
6500K Konica Minolta's standard data
cd/m
2
* For details, refer to the pages given in the above table.
keys.
30
)
2