Cleaning; Place Thor Vm1 In The Dock - Honeywell THOR VM1 User Manual

Cleaning

If it becomes necessary to clean the Thor VM1, dock, peripherals or mounting hardware see:
• Cleaning the Thor VM1 and the Dock
• Cleaning the Touch Screen

Place Thor VM1 in the Dock

Back of Thor VM1
Back of Thor VM1
1. Locate the notch on the upper rear of the Thor VM1.
2. Slide this notch over the top lip of the dock. Slide the Thor VM1 from side to side on the dock to make sure it fully engages
on the lip of the dock. If the Thor VM1 cannot be slid side to side, the lip is engaged.
3. Pull the quick release lever on the Thor VM1 down and push the Thor VM1 against the dock.
4. Release the quick release lever. The quick release lever catches the lower lip on the dock and secures the Thor VM1 to the
dock. Be sure the red quick release lever is pushed all the way in to secure the Thor VM1 to the dock.
5. If necessary, adjust the viewing angle of the Thor VM1.
When the Thor VM1 is placed in the dock, the following may happen:
• If the Thor VM1 is off and power is connected to the dock, the Thor VM1 may boot when placed in the dock. See
(page 5-5).
• If the Thor VM1 is on and power is connected to the dock, the Thor VM1 power management timers may change when the
Thor VM1 is placed in the dock. See
When the Thor VM1 is removed from the dock, the following may happen:
• If the Thor VM1 is on and power is connected to the dock, the Thor VM1 power management timers may change when the
Thor VM1 is placed in the dock. See
4 - 18
(page 2-10)
(page 2-10)
Notch on
Thor VM1
Release Lever
Power Scheme (page 5-89).
Power Scheme (page 5-89).
Front of Dock
Upper Lip on Dock
Lower Lip on Dock
Front of Dock
AutoOn